2007 Tahoe - How do you intall the left rear suspension poss. sensor and link?
Mar 16, 2011 at 3:49 PM
Rear Suspension Sensor
2007 CHEVROLET TAHOE
PP52
- MEMBER
- 1 POST
- FOLLOW
Advertisement
The removal of the suspension position sensor was fairly basic according to database.
Image (Click to enlarge)
Jun 15, 2011 at 3:10 PM
Safely,Raise and support the vehicle, remove tire left or right.
As far as the link assembly. Remove the esc sensor from vehicle. While supporting the sensor level by hand, twist the link rod to remove it from ball stud.
To install link rod on ball stud, database shows using a hose clamp, to squeeze together
As far as the link assembly. Remove the esc sensor from vehicle. While supporting the sensor level by hand, twist the link rod to remove it from ball stud.
To install link rod on ball stud, database shows using a hose clamp, to squeeze together
Jun 15, 2011 at 3:29 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.