Sunday, August 12th, 2012 AT 7:43 PM
KEARSE88
- MEMBER
- 2006 HUMMER H3
- 145,000 MILES
I need to replace the crankshaft angle sensor how do I do that?
SPONSORED LINKS
Where is the crankshaft position sensor on a 2006 Hummer H3
3 Replies
KHLOW2008
- MECHANIC
- 41,815 POSTS
The crankshaft sensor is in the rear of the block near the starter here is a guide and a diagram below to show you the location.
https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement
Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Cheers
https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement
Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Cheers
Image (Click to make bigger)
SPONSORED LINKS
Was this helpful?
Yes
No
+7
Sunday, August 12th, 2012 AT 7:55 PM
JAMIE
- MEMBER
- 1 POST
- 2006 HUMMER H3
- 5 CYL
- 4WD
- AUTOMATIC
- 74,000 MILES
Hummer h3 2006 crankshaft senser replace twice back to back and still missing
Was this helpful?
Yes
No
+1
Thursday, October 4th, 2018 AT 3:51 PM
(Merged)
FACTORYJACK
- MECHANIC
- 4,159 POSTS
That is because the crankshaft sensor will not cause misfire. Does this occur only at idle, or all the time and under load. A couple of common causes for misfire is water in the #1 spark plug port, a faulty ignition coil. If it counts misfires at idle that are barely noticeable, and diminish with increased engine speed, it could have valves leaking in the cylinder head. I believe there is a bulletin on this, and the water intrusion in the plug ports.
Was this helpful?
Yes
No
+3
Thursday, October 4th, 2018 AT 3:51 PM
(Merged)
Related Crankshaft Sensor Location Content
Sponsored links
SPONSORED LINKS
How to fix an engine that wont start
