2006 Ford Crown Victoria Took Off Driver Door Panel Tried Reconnct Horn Uder Hood

2006 FORD CROWN VICTORIA
104,598 MILES
Avatar
DDORTCH
  • MEMBER
  • 2 POSTS
wont start took off driver door panel and tried to reconnect the horn under the hood heard a spark and now car wont start, you turn the key and its silence.
Image (Click to enlarge)
Attached Media
Feb 6, 2012 at 12:33 AM
Advertisement
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Why did you take off the door panel to reconnect the horn? Where was the spark heard?

Does the engine turn over? Do you get gas to the cylinders? What about spark?
Feb 6, 2012 at 12:50 AM
Avatar
DDORTCH
  • MEMBER
  • 2 POSTS
the speaker wires wher cut and i connected them and heard a spark near the upper right side of the hood.. i jumped the a fuse under the hood and it starts but the security system dosnt work and the keyless remote either
Feb 6, 2012 at 5:54 AM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
You may have damaged the keyless remote/security system. If something sparked when you connected a wire/wires to the speaker in the door, the wrong wire was probably hooked up. It may have been a wire to the power lock solenoid, since now that system isn't working. You may also have a faulty relay for the lock system.

Our reference material doesn't show an OEM security system.
Feb 6, 2012 at 6:12 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.