2004 Mitsubishi Endeavor Truck Stopped Working While Running

2004 MITSUBISHI ENDEAVOR
130,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
the truck stopped working while running
Oct 29, 2012 at 10:18 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
What is it doing right now-cranking over and will not start-specify
Oct 30, 2012 at 1:31 AM
Avatar
KMALEON
  • MEMBER
  • 1 POST
I found motor oil on the spark plugs, I changed all of them and the failure continues, the mechanic clean the air system and tried to open the MAF sensor, the engine is now working but is not steady it sounds like it is going to fail again, if you try to start the engine right after you turned it off you will have to give some gas because then it strugles, this is driven me nut!!

I was reading some of the comments and it looks the failure could be related to CRANK sensor.
I appreciate your help.
Oct 31, 2012 at 12:04 AM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Are you still getting oil in the cylinders? If its the CPS I don't think it will start-Check the fuel pressure if its within specification and check the idle speed controller-
Oct 31, 2012 at 12:22 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.