Engine not running

2004 CHRYSLER PT CRUISER
132 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
No fire at coil pack terminal. What is the possible cause?
Nov 19, 2012 at 2:54 PM
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
It sounds like the crankshaft sensor is not working. Here is a guide to show you what you are in for and the diagrams below will show you the location for your car:

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

Check out the diagrams (below). Please let us know what happens.

Cheers
Nov 19, 2012 at 3:00 PM
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
Our car just quit running while we were waiting for the green light. so we put it on park then re-start it. then while we were on the store and started backing out from the parking lot, it shut off again. last week my husband changed the oil. When we tried to use the car the following day, the car started, but as soon as we backed up from the parking lot, it shut off again. until now, our car will not start. We changed the battery June, 2012. The starter, alternator and timing belt are new. In your opinion, what seems to be the problem with our car? Thanks in advance for your help.
Aug 4, 2018 at 11:43 AM (Merged)
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
check fuel pressure.

check for any vacuum lines off.

is the check engine light on??

Roy
Aug 4, 2018 at 11:43 AM (Merged)
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
My car ran out of petrol, I have now filled up again but it will not start. What could be the problem? I have tried almost everything but will not start.
Aug 4, 2018 at 11:45 AM (Merged)
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Check fuel pump pressure. The pump may have been damaged.
Aug 4, 2018 at 11:45 AM (Merged)
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.