Where is the fluid level sensor located at on 2004 Chevy malibu maxx, v6 4.3 L?
Jan 13, 2013 at 5:10 PM
2004 Chevrolet Malibu Fluid Level Sensor Located On Chevy Maxx V6 4 3 L
2004 CHEVROLET MALIBU
LACYL
- MEMBER
- 3 POSTS
- FOLLOW
Advertisement
low coolant is on the radiator drivers side down a little. if not, then in the bottom of the plastic bottle.
Roy
Roy
Jan 13, 2013 at 5:28 PM
This is regards to the brake fluid light staying on. Have checked the brake fluid reservoir & fuses, etc. Also, the cruise control no longer works, since the light has been staying on.
Jan 13, 2013 at 5:36 PM
thats new information, there are several fluid sensors.
the light comes on for low fluid, abs malfunction, hydraulic failures and hand brake applied.
the sensor is in the master cylinder top plastic.
roy
the light comes on for low fluid, abs malfunction, hydraulic failures and hand brake applied.
the sensor is in the master cylinder top plastic.
roy
Jan 13, 2013 at 5:41 PM
Could it possibly be a bad handbrake lever switch? Should I check that first or does that not have any revelance to the cruise control not working?
Jan 13, 2013 at 6:06 PM
ok, so the cruise is not working too??? more new information.
no, has nothing to do with cruise.
disconnect the hand brake switch and see if the light goes out
Roy
no, has nothing to do with cruise.
disconnect the hand brake switch and see if the light goes out
Roy
Jan 13, 2013 at 7:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.