HYUNDAI TIBURON COTTER PIN PROBLEM
2003 Hyundai Tiburon • 250,258 miles
I need to know, when installing the front wheel bearing on the passenger side, if when I put on the castle nut I torque it to a certain ft. lb. or tighten it all the way in then back it off to the first spot available to put the cotter pin in.
Certain ft lbs and then back off till hole is open
How can I find out the specific ft lbs without a repair manual?
148-192 ft lbs.
When i torque the castle nut on my new tie rod ends to the specified 45 ft-lbs, the nut is several turns past the hole in the stud for the cotter pin. Is this OK? (98 grand prix)
3 answers • 1998 Pontiac Grand Prix • 171 miles
Tires and Wheels problem 1996 Dodge Ram Four Wheel Drive Automatic How do you remove the wheel bearings from the front passenger side? I have removed cotter pin and slotted bolt ...
1 answer • 1996 Dodge Ram
Drive Train Axles Bearings problem 1994 Ford Explorer 6 cyl Four Wheel Drive Automatic I am following the instructions in the Chilton's manual to replace the front wheel ...
1 answer • 1994 Ford Explorer
Suspension problem 2003 Ford Windstar V6 Front Wheel Drive Automatic 39000 miles My Windstar has noise that increases as I speed up but which sounds like a wheel bearing. When ...
1 answer • 2003 Ford Windstar