Reset oil mileage display

Tiny
CISCOKID5941
  • MEMBER
  • 2003 BMW Z4
  • 6 CYL
  • 2WD
  • MANUAL
  • 44,211 MILES
How do I reset tthe oil mleage display after oil change. 2003 BMW Z4 2.5 engine
Sunday, July 24th, 2011 AT 1:48 PM

1 Reply

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
There are a few versions of resetting ptocedures. See if this works.

SERVICE INTERVAL LIGHT RESET - PROCEDURE 2

Reset service light by performing the following:

1. Ignition key must be in OFF position.

2. Press and hold trip odometer reset button in the instrument cluster (left button), and turn ignition key to first position.

3. Keep the button pressed for approximately 5 seconds until one of the following words appear in the display: "OIL SERVICE",
or "INSPECTION", with "RESET".

4. Release reset button and press it again until "RESET" begins to flash in the display. See Fig. 3 and Fig. 4.

5. Service due is shown with "RESET" if coded minimum consumption limit has been reached and resetting is possible. If "RESET" is not shown, minimum limit has not been reached and resetting is not possible.

6. While "RESET" is flashing, press left button briefly to reset service interval. After display has shown new interval, following will appear: "END SIA".

7. System can only be reset again after 2.5 gallons of fuel have been consumed.
Was this
answer
helpful?
Yes
No
Sunday, July 24th, 2011 AT 2:13 PM

Please login or register to post a reply.

Sponsored links