I know this is an old post, but in case someone else is reading this...

The brake wear indicator is a 2 wire sensor, when the pad that holds
the sensor wears to the point that one of the wires breaks, then
a warning light in the dash will come on.

There is NO audible noise, just a round circle with 3 lines on
either side.

When new pads are installed, the new sensor is plugged into the
wiring harness plug and the warning light should be OFF.

If the warning light is still ON, then there is a wiring problem (a
broken wire in the circuit).

If you are also hearing a BEEPING noise, then that is usually part
of the ABS warning system.

Thomas

http://fkh161.ca

Answered by exovcds
0 questions asked