2002 Mitsubishi Galant Repair Question
Asked on February 29, 2012
Heater blowing cold air
The heater core hoses are cold, but engine is fully warm...is there a valve motor which controls fluid flow or something electrical, or is the core just clogged
Asked by larry collettAnswer
Replied on February 29, 2012
The heater control valve motor is located below the dash on the passenger side. First remove the glove box, then the lower trim panel. Before removing the lower trim panel remove the center trim around the radio and A/C controls. After removing the lower trim panel, the heater control valve motor is on the left side underneath the automatic compressor controller, connected to the heater control unit. if it's the problem you can replace or just manually open.
Replied on February 29, 2012
check this out. http://www.youtube.com/watch?v=HywkYSNRGug