turned hand wheel

2002 FORD CROWN VICTORIA
127,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
TARI2005
  • MEMBER
  • 1 POST
The hand wheel is turned upside down, how do i turn it back?
Jan 23, 2011 at 12:40 AM
Advertisement
Avatar
IMPALASS
  • CAR REPAIR CONTRIBUTOR
  • 3,112 POSTS
Hello –

When you say hand wheel are you talking about the steering wheel? If you are you need to pull it and turn it around. The wheels need to be totally straight and there will be a line up mark on the steering wheel and the shaft and those line up.

If you have never done this before and don’t have pretty good mechanical ability….please have this done. The air bag has to be disconnected for this and if done improperly the air bag could go off or not function correctly in a crash. Also, static electricity can set off the air bag. So it is very dangerous.

You also need to get a steering wheel puller. You might consider taking it somewhere as this shouldn't cost too much to do.

Mar 27, 2011 at 11:34 PM
Avatar
IMPALASS
  • CAR REPAIR CONTRIBUTOR
  • 3,112 POSTS
Hello –

Also, it looks like you may have some recalls on your vehicle. The dealer may fix these for free. Please contact the dealer service department, give them the VIN number of your car and have them check on these to see if they apply to you.

02M01S6
08/31/2004
Recall - Tube Mounted EGR Pressure Sensor Defect

03S08
01/01/2004
Recall - CNG Fuel Tank Insulator Installation

NHTSA03V472000
11/01/2003
Recall 03V472000: Fuel Tank Insulator Installation

NHTSA02V249000
09/01/2002
Recall 02V249000:Fuel Tank 'T' Fitting Replacement

02S39
08/01/2002
Recall - Fuel 'T' Fitting Defect (CNG)
Mar 27, 2011 at 11:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.