engine cranks but no start no signal to coil

2002 CHRYSLER SEBRING
125,000 MILES
Avatar
BILLY C
  • MEMBER
  • 21 POSTS
2002 chrysler sebring no start checked cam & crank sensor with mt2500 scanner shows signal have fuel pressure no signal to coil timing belt ok no signal to coil checked cam & crank sensors with mt2500 scanner shows signal have fuel pressure timing belt ok fuses ok
Dec 6, 2011 at 4:22 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Check for spark to the plugs and make sure the fuel pressure is within spec.
Dec 6, 2011 at 4:24 PM
Avatar
BILLY C
  • MEMBER
  • 21 POSTS
already checked spark no spark fuel pressure ok
Dec 6, 2011 at 4:31 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Have you checked wiring between sensors and PCM?
Dec 6, 2011 at 4:36 PM
Avatar
BILLY C
  • MEMBER
  • 21 POSTS
wiring should be ok if scanner shows signal for cam & crank sensors (I dont have wiring diagrams)
Dec 6, 2011 at 5:29 PM
Avatar
BILLY C
  • MEMBER
  • 21 POSTS
still need answer to question
Dec 7, 2011 at 3:40 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Schematic attached
Image (Click to enlarge)
Attached Media
Dec 7, 2011 at 5:45 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.