found a large split in a vaccum hose car wont start

2001 VOLKSWAGEN JETTA

180,000 MILES

CHRISJAMES

MEMBER
1 POST
FOLLOW

i have a 01 wolfsburg jetta 1.8 turbo my car smelled funny last time i parked it then when i went to start it it turns over but wont start found there was no oil added some found oil in my plugs cleaned them then noticed it looked like all the oil came out of a large split in my vaccum line taped that up tight as a temp fix til i get a new hose but still wont start im getting codes po171 wich seems like its prob the vac hose and po321 po322 wich is my crankshaft position sensor wich iv been working on but thanks to vw thats a long story cars been running with that so guessing its this new issue po171 but seems like nothing states it will cause the car to not run at all?

Oct 10, 2012 at 1:43 PM

HMAC300

CAR REPAIR CONTRIBUTOR
48,601 POSTS

check your fuel pressure. it should be 2.5 bar code 171 is engen running lean.

Dec 20, 2016 at 11:17 AM

KHLOW2008

CAR REPAIR CONTRIBUTOR
41,814 POSTS

A vacuum leak can and would result in P0171. If it is a large leak, you would have difficult or non starting issues.

Dec 20, 2016 at 11:17 AM

EXOVCDS

CAR REPAIR CONTRIBUTOR
1,883 POSTS

If the crank sensor code keeps coming back, then that's your no-start.

Might have been intermittent in the past, and is a hard fault now.

Otherwise, fuel pumps are common at this age.

Thomas

Dec 20, 2016 at 11:17 AM

EXOVCDS

CAR REPAIR CONTRIBUTOR
1,883 POSTS

Is the lean code "additive" or "Multiplicative"?

- add = vacuum leak after throttle body
- multi = before throttle

If you have not yet cleared the codes, check measuring block 32
for long term fuel trim values and post the percentages here.

The hose you replaced, is it the one on the right of the engine valve
cover?

That should not keep the car from running.

Thomas

Dec 20, 2016 at 11:17 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.