what is the code number as it may be a vacuum leak causing this.

idle control motor may be mal functioning as well

Roy

Answered by ASEMaster6371 (expert)
24,973 answers provided

I do not remember the code # but is was "Lean Bank 1" I believe as the description

Response from HenryJ
1 question asked

is the light back on??

roy

Answered by ASEMaster6371 (expert)
24,973 answers provided

No it's currently off. I disconnected the MAF to see if that would get it back to stored factory codes, but it ran the same.

Response from HenryJ
1 question asked

doing that does nothing but create issues. never dis connect a sensor while running

Roy

Answered by ASEMaster6371 (expert)
24,973 answers provided

Cleared all codes this weekend, just to be sure nothing was caused by the unplugged MAF. Removed the IAC and cleaned it and the TB passages, cleaned the MAF, changed air filter, and coolant temperature sender. Tested fuel pressure, 48 psi running, 52 psi regulator vacuum un plugged. Checked the resistance of the air charge sensor seems good 2.6 K-ohm.
Same problem, when first started "cold" runs fine @ high idle for 1 minute, then idle drops to the point of stalling, if I keep it running by feathering the throttle it clears up in 3 minutes and runs fine, until next cold start. No SES light set.

Response from HenryJ
1 question asked