how to replace air mix mode actuator blend door
Aug 25, 2012 at 7:24 PM
not giving air on the vents when you turn on a/c
2001 FORD E-SERIES VAN
CLEOFASGALVAN
- MEMBER
- 1 POST
- FOLLOW
Advertisement
REMOVAL
Disconnect the battery ground cable.
Remove the access panel.
Use a screwdriver to pry the access panel out.
Remove the vacuum line.
Remove the two screws.
Remove the vacuum control motor.
1 Lift up on the vacuum control motor arm to disengage it from the door crank.
2 Remove the vacuum control motor.
INSTALLATION
Follow the removal procedure in reverse order.
make sure the vacuum line under the hood is not disconnected or broken.
Roy
Disconnect the battery ground cable.
Remove the access panel.
Use a screwdriver to pry the access panel out.
Remove the vacuum line.
Remove the two screws.
Remove the vacuum control motor.
1 Lift up on the vacuum control motor arm to disengage it from the door crank.
2 Remove the vacuum control motor.
INSTALLATION
Follow the removal procedure in reverse order.
make sure the vacuum line under the hood is not disconnected or broken.
Roy
Aug 25, 2012 at 7:59 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.