Turn signals and Hazards not working.

MARINA3141

MEMBER
2003 CHRYSLER PT CRUISER
2.4L
4 CYL
FWD
AUTOMATIC
140,000 MILES

The turn signals and hazards are not working on my car. The bulbs are working just find. I replaced the fuses, multi functional switch, relay, and still nothing. The headlights, fog lights, wipers, etc are still working. It's just the turn signals and hazards and inside on the panel show nothing either.

5 Replies

HMAC300

MECHANIC
48,601 POSTS

You probably need anew combination flasher see pic.

Image (Click to make bigger)

Was this

answer

helpful?

Yes

No

-1

Thursday, June 18th, 2015 AT 6:36 AM

LESR1967

MEMBER
2 POSTS
2001 CHRYSLER PT CRUISER
84,000 MILES

Replaced switch due to fog lights coming on while car off. Now no turn signals or four ways.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Monday, March 4th, 2019 AT 5:19 PM (Merged)

CADIEMAN

MECHANIC
3,544 POSTS

Those are 2 different circuts. Check the signal fuse. Then check the flashers.I hope you installed the switch right because both of these are controlled by the signal switch.

Was this

answer

helpful?

Yes

No

-1

Monday, March 4th, 2019 AT 5:19 PM (Merged)

184583092

MEMBER
2 POSTS
2004 CHRYSLER PT CRUISER
13,900 MILES

Check grounds on what? Remote works locks locks works but with no turn signal bulds flashing and no horn sounnd and far as the remote start I think once I get the lights flashing when I lock or unlock the doors the remote start will work again oh I also checked all the fuses none are bad 3, 10, 13 fuses in the dash all good

Was this

answer

helpful?

Yes

No

+1

Monday, March 4th, 2019 AT 5:19 PM (Merged)

CADIEMAN