Right turn signal not working

Tiny
BCORTIS
  • MEMBER
  • 2000 PONTIAC BONNEVILLE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 140,000 MILES
My right turn signal doesn't work in the front or the back and the blinking indicator on the dash does not work. A couple people have checked my fuses, the bulbs, tried bulbs from the other side that worked and they did not work on the right side. Someone said it could be something like a sensor or switch in the column? I would like to try to narrow it down before I start buying all types of parts? Any ideas? Is this something that I would have to take to the (overpriced) dealers or get fixed relatively easy? Any feedback would be greatly appreciated!
Monday, March 7th, 2011 AT 8:08 PM

17 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
What happens is the turn signal flasher and hazard flasher are the same and they go out causing one side or both the stop working.

Here is a wiring diagram and a test guide so we can confirm the problem and get it fixed.

https://www.2carpros.com/articles/how-to-use-a-test-light-circuit-tester

this guide can help as well

https://www.2carpros.com/articles/turn-signals-not-working-blinker

Turn signal wiring and location diagrams below:

Please let us know what happens so it will help others.

Cheers
Was this
answer
helpful?
Yes
No
+3
Monday, March 7th, 2011 AT 9:08 PM
Tiny
BCORTIS
  • MEMBER
  • 4 POSTS
Only the left side works I will need to test ht system to see what I come up with but it sounds right what you are saying.
Was this
answer
helpful?
Yes
No
+1
Monday, March 7th, 2011 AT 9:20 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
At the flasher module, apply battery voltage to the Light Green wire. If the lights come on, you have a faulty column switch. If lights do not come on, apply battery voltage to the Dark Blue wire and if lights come on, the flasher module is faulty.

If lights do not come on, you have to check for an open circuit in the wiring circuit from relay to the bulbs.
Was this
answer
helpful?
Yes
No
Monday, March 7th, 2011 AT 9:39 PM
Tiny
BCORTIS
  • MEMBER
  • 4 POSTS
I finally got a friend to come check the wires. He verified that it is the flasher module. However, he was unable to locate the module.
Where is that located and do I need to do anything special to take it out to be replaced?
Thank you.
Was this
answer
helpful?
Yes
No
+1
Monday, April 11th, 2011 AT 3:38 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
It is under left side of dash but I could not find any location diagram to show you.

It is a plug and use component so nothing special about it. Book time is 12 minutes for replacement so should be rather easy.
Was this
answer
helpful?
Yes
No
Monday, April 11th, 2011 AT 8:12 PM
Tiny
BCORTIS
  • MEMBER
  • 4 POSTS
Excellent! I replaced the hazard switch and bam! All fixed

I really appreciate all your help and your patience :-)

Thank you!
Was this
answer
helpful?
Yes
No
Monday, April 11th, 2011 AT 8:45 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
In our database, it is refered to as " Turn Signal/Hazard Flasher Module".

Commonly used name for this component is "Flasher Relay".

Other names are " Hazard Warning Flasher" or Turn Signal Flasher"
Was this
answer
helpful?
Yes
No
+1
Tuesday, April 12th, 2011 AT 3:49 PM
Tiny
BIGPHILLYDOG
  • MEMBER
  • 1 POST
  • 2000 PONTIAC BONNEVILLE
  • 3.8L
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 127,467 MILES
Right side works, no left signals at all. No front rear or dash
Was this
answer
helpful?
Yes
No
+1
Thursday, October 19th, 2017 AT 2:37 PM (Merged)
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
I assume bulbs are good. Check to see if power is going to them it may be a ground issue or it may be a turn signal switch
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:37 PM (Merged)
Tiny
MYNOX21
  • MEMBER
  • 4 POSTS
  • 2002 PONTIAC BONNEVILLE
  • 100,000 MILES
I check the fuses and the voltage to the turn signals and the power windows
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:37 PM (Merged)
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check the relays in the under hood fuse box, for doors and windows. Then check your switch on teh drier's side it may be bad. If yo uhave the digital dash that may need to be fixed.
Was this
answer
helpful?
Yes
No
+1
Thursday, October 19th, 2017 AT 2:37 PM (Merged)
Tiny
DDWINDFW
  • MEMBER
  • 2 POSTS
  • 1997 PONTIAC BONNEVILLE
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 19,100 MILES
Electrical problem
1997 Pontiac Bonneville 6 cyl Two Wheel Drive Automatic 191, 00 miles

My 1997 Bonneville turn signals suddenly stopped working. Both passenger and driver side, front and back. The inside indicators also don't work. However, the emergency flashers do work fine. Mechanically, everything seems to work -- the switch still clicks off after a turn, but there isn't a clicking sound, either.

Appreciate any thoughts!
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:38 PM (Merged)
Tiny
LEGITIMATE007
  • MECHANIC
  • 5,121 POSTS
Yes, it sounds like you need a new flasher fuse, even though your flasher fuse may be bad, your hazzard lights will still work.
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:38 PM (Merged)
Tiny
DDWINDFW
  • MEMBER
  • 2 POSTS
Thanks for the info -- I neglected to include that I have checked the fuse and it is fine.
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:38 PM (Merged)
Tiny
LEGITIMATE007
  • MECHANIC
  • 5,121 POSTS
Not fuse, flasher fuse/relay. Its probably silver and round in this vehicle, but it can also be black and rectangular or yellow and big like a square relay but rectangular
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:38 PM (Merged)
Tiny
MAG777
  • MEMBER
  • 1 POST
  • 1999 PONTIAC BONNEVILLE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 13,000 MILES
Electrical problem
1999 Pontiac Bonneville 6 cyl Front Wheel Drive Automatic 130, 00 miles

my turn signals quit working and need to know what my options are and where to look first to fix?
Was this
answer
helpful?
Yes
No
Thursday, October 19th, 2017 AT 2:38 PM (Merged)
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Hello, I'd check the fuse and check that the fuse circuit is hot with the key on. Next, I would check the flasher.


https://www.2carpros.com/forum/automotive_pictures/170934_pontiac_bonneville_1.jpg



If all that is ok, next I look at the turn switch.
Was this
answer
helpful?
Yes
No
+1
Thursday, October 19th, 2017 AT 2:38 PM (Merged)

Please login or register to post a reply.

Sponsored links