It is a 3.8. How do I go about checking for losing spark when it starts and where is the crank sensor at?
Sep 11, 2011 at 4:42 PM
Car wont start
2000 PONTIAC BONNEVILLE
GMORRILL
- MEMBER
- 10 POSTS
- FOLLOW
Advertisement
Hi:
I think I answered your last question. If you refer to our home page, there are directions on how to check for spark under the DIY section. Follow the directions and see if the spark stops after it stops. As far as the crank sensor, it is behind the harmonic balancer. I attached a picture to help you locate it. It is at the bottom front of the engine.
Let me know if this helps.
I think I answered your last question. If you refer to our home page, there are directions on how to check for spark under the DIY section. Follow the directions and see if the spark stops after it stops. As far as the crank sensor, it is behind the harmonic balancer. I attached a picture to help you locate it. It is at the bottom front of the engine.
Let me know if this helps.
Image (Click to enlarge)
Sep 11, 2011 at 4:47 PM
Thanks for your response gives another avenue to look at.
Sep 11, 2011 at 5:06 PM
I hope it helps. Let me know if you have other questions. It's harder when I'm not there, but I will do my best to help.
Joe
Joe
Sep 11, 2011 at 5:19 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.