2000 Gmc Sierra Bearing Rear Differenenteral Went Out Locking Rearend Upp Tight

2000 GMC SIERRA
13,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
the bearing in the rear differenenteral went out locking the rearend upp tight cant get to the bolt to pull the pin that holds the axels in place any idea on how to get it to turn
Nov 27, 2012 at 3:22 PM
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
loosen pinion bolt an dbolts holding axle caps, then use a larger scredriver on the gears to see if it wil force around. you may need to hit pinion after loosening nut next time make sure to check your oil level in rear end.
Nov 27, 2012 at 3:58 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.