2000 Dodge Truck Ram 1500 2wd 5 9l Will Start

2000 DODGE TRUCK
24,000 MILES
Avatar
DOUGHART1
  • MEMBER
  • 4 POSTS
I replace the trans,the neg cabel,crankshsft postition sensor,I have a [no bus] and no power to the fuel inj,coil,comeing for the PCM computer,I have ckeck fuse and relays where do i go from here. Thanks
Oct 13, 2012 at 7:01 PM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
does the check engine light work??

Roy
Oct 13, 2012 at 7:02 PM
Avatar
DOUGHART1
  • MEMBER
  • 4 POSTS
Yes the check engine light work but when i uae the OBD scaner it will not read it.
Oct 13, 2012 at 8:06 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
first, lets do basics.


fuel pressure and spark test. see if there is any spark and check fuel pressure

Roy
Oct 13, 2012 at 9:17 PM
Avatar
DOUGHART1
  • MEMBER
  • 4 POSTS
Iam not getting any power going to the fuel pump or to the spark plug comeing from the PCM computer. PCM is new
Oct 13, 2012 at 11:07 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
new?? was it flashed before installing??

check for 12 volts to the positive side of the coil.

Roy
Oct 13, 2012 at 11:50 PM
Avatar
DOUGHART1
  • MEMBER
  • 4 POSTS
Yes PCM is new and they flashed it. no power comeing from PCM to coil
Oct 14, 2012 at 2:55 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.