2000 Chevrolet Silverado Truck Cranks Won T Start Replaced Fuel Pump Filter

2000 CHEVROLET SILVERADO
256,000 MILES
Avatar
ALFRED BENALLY
  • MEMBER
  • 3 POSTS
truck cranks won't start , replaced fuel pump, fuel filter, crank and cam shaft sensor, pcm, timing chain, battery, coil and code reader won;t read code from truck
Jan 21, 2013 at 5:48 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Are you getting good spark to the plugs and fuel pressure?
Jan 21, 2013 at 6:18 PM
Avatar
ALFRED BENALLY
  • MEMBER
  • 3 POSTS
Yes everything works took it to dealer they told me it was pcm nothing was running after i replaced anti brake module wouldnt start after that
Jan 21, 2013 at 6:46 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
A bad PCM could cause this. However, you say you are getting spark and fuel to the engine. Are the injectors getting power?
Jan 21, 2013 at 6:50 PM
Avatar
ALFRED BENALLY
  • MEMBER
  • 3 POSTS
Replaced pcm and have power to injectors
Jan 21, 2013 at 7:54 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
If you have spark and fuel, it should run. Have you checked engine compression? Will it start with starting fluid?
Jan 21, 2013 at 8:25 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.