CADILLAC SEVILLE SENSOR PROBLEM
2000 Cadillac Seville • 113,000 miles
Where is the Shift Position Sensor located on the 2000 Cadillac Seville?
November 12, 2012.
November 12, 2012.
-What is the exact code that you get-that you came up with this sensor-You sure its not the Automatic Transaxle Input Shaft Speed Sensor or the Vehicle Speed Sensor?
Sorry, I do not know what the code(s) were. I was just told by the person that ran the codes and I explained the problem to that I needed the shift position sensor. If you like I have explained the situation below: I got into my car with no previous problems. I started the car placed it in reverse and backed out of my parking space. Placed the shifter into 'Drive' and the car still wanted to back up. I played with the shifter back and forth for a short while and then turned the key off. I then turned the key back to start and absolutely no response. It was as if the battery was completely down or the security system was triggered. Note: the dash display still showed the transmission to be in reverse.
Just wondering what sensors i need to replace.codes as follows.p0135,p0155,p0133.two of the codes say bank 1 sensor 1 the other says bank2 sensor 1.I think bank means driver or ...
2 answers • 2002 Dodge Intrepid • 100,500 miles
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles