No starter operation

1999 BUICK LESABRE
73,000 MILES
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
when turn key to start the starter don't make any noise, i can connect a jumper lead between the battery and the ignition switch wire terminal on the solenoid the starter will operates, i connect a test light to the ignition switch wire terminal on the solenoid the test light want come on when turn key to start, and the turn signal don't operates but the hazard flashers will, the radio will operates, but i din't see any instrument panel cluster lights on but the engine want start when ignition switch is on, while turning starter with jumper wire.
Sep 21, 2012 at 3:32 AM
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Symptom indicates a faulty ignition switch.

IGNITION SWITCH

Turn ignition off. Disconnect 48-pin connector C202 located near base of steering column. Using DVOM, check for continuity between specified terminals with ignition switch in specified position. See
IGNITION SWITCH CONTINUITY TEST table. If continuity does not exist as indicated, repair wiring harness between ignition switch and connector C202 or replace ignition switch.
Image (Click to enlarge)
Attached Media
Sep 21, 2012 at 5:36 AM
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
i disconnect a 42-pin connector but i am not sure i disconnect the right connector,i didn't see any number on the connector like D5,B2,C6,i don't know which terminals to check for CONTINUITY.
Sep 22, 2012 at 1:31 AM
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Here is the diagram for the identifiaction.
Image (Click to enlarge)
Attached Media
Sep 22, 2012 at 8:19 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.