flywheel and clutch

1998 TOYOTA TACOMA
114,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
BEDDINGFIELD
  • MEMBER
  • 2 POSTS
i had flywheel turned and replaced clutch and it still does not work wont go into gear but it will go into gear when the truck is not running what is wrong
Apr 11, 2011 at 1:33 AM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
1996 Ford F150 Water leaking
1998 Toyota Tacoma flywheel and clutch

If clutch master cylinder and slave are good and bleed properly-You need to check the clutch assembly: Pilot busing, disc, cover, release bearing and clutch fork
Apr 11, 2011 at 1:43 AM
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
It is a fault with the clutch system. Ensure there is sufficient travel of the clutch fork to release the clutch.

If clutch pedal is low, check the clutch master cylinder push rod adjustment.
Apr 11, 2011 at 1:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.