1998 Ford Expedition This A4wd Mode Light Flashing Hi Low Work Fine Torque On

1998 FORD EXPEDITION
50,000 MILES
Avatar
TRAPPERBO
  • MEMBER
  • 3 POSTS
This expedition has a4wd mode with the light flashing. $hi and low work fine. Where is the torque on demand and 4x4 relays located. Aldata says behind centre of dash. I removed the dash centre cover and all thats there are 3 doorlock relays and the airide module. Any body ever find them?
Dec 8, 2012 at 11:39 PM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
before throwing parts at it, why dont you find the failure, then replace the bad part.

have the code pulled for the light and get back to us with the code.

Roy
Dec 8, 2012 at 11:40 PM
Avatar
TRAPPERBO
  • MEMBER
  • 3 POSTS
Not unterested in throwing parts on it. I'mlooking for the tod relay to do a pin test. There's no power on the transfercase plug, term. 16, but there is output from the jem module. A more exact location would be much appreciated. Thanks in advance.
Dec 10, 2012 at 11:59 PM
Avatar
TRAPPERBO
  • MEMBER
  • 3 POSTS
Found the tod relay behind the dash. I tested the pin circuits and had a broken wire from the Gem Module to the Tod relay./ Thanks for Your Help Guys.
Dec 12, 2012 at 9:55 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.