the speed sensor was made out of plastic and some of it remained in the housing. How does one get it out.
Jun 24, 2011 at 11:28 PM
98 ford contour svt standard trans
1998 FORD CONTOUR
GTRACY
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Sorta depends on amount/ is it stuck?/ loose etc....describe whats still in there or post a few good pics of what's been pulled out!
I have had good luck heating up pins/ nails etc--almost red hot and stabbing it into plastic--let it cool then extract.
Kinda depends on what "BAD" might could happen, using whatever method!
If you post pics, might give us better theory's to shoot back!
Regardless, let us know your outcome!
The Medic
I have had good luck heating up pins/ nails etc--almost red hot and stabbing it into plastic--let it cool then extract.
Kinda depends on what "BAD" might could happen, using whatever method!
If you post pics, might give us better theory's to shoot back!
Regardless, let us know your outcome!
The Medic
Jun 24, 2011 at 11:49 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.