chrysler, sebring lxi 1998 stalls

1998 CHRYSLER SEBRING
140,000 MILES
Avatar
JORGE CARRO
  • MEMBER
  • 2 POSTS
My car runs good for about 2 hours and then in the middle of the road it shuts down by itself, I wait 10 minutes & start it again runs for 10 minutes & shuts down again. What could be the problem?

Apr 30, 2012 at 7:58 PM
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
CEl on? could be crank sensor. this a known symptom for this event.
Apr 30, 2012 at 8:21 PM
Avatar
JORGE CARRO
  • MEMBER
  • 2 POSTS
Hi, thanx forthe answer, were is the crank sensor located @?
May 1, 2012 at 3:57 AM
Avatar
CHOPPER
  • MEMBER
  • 16 POSTS
Crank sensor will throw a code. Scan first.. My guess fuel pump you are right on schedule for one.
May 1, 2012 at 4:14 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
after you check the crank sensor, the distributor is another common failure as oil gets past the bushings and get into the cap and rotor area.

the crank sensor is mounted on the bellhousing below the distributor. it has a 100mm bolt and a 2 wire connector.

Roy
May 2, 2012 at 1:37 AM
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
100mm bolt! i know that sucker aint gonna fail?
May 2, 2012 at 3:26 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.