how to chane a stater on 97toyota tacoma 4x4 2.7
Dec 28, 2010 at 12:22 PM
stater
1997 TOYOTA TACOMA
GLORIOSD
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Disconnect the negative battery cable.
Remove the nut and disconnect the battery cable from the magnetic switch on the starter motor.
Detach the remaining electrical connections at the starter.
Remove the nuts and/or bolts securing the starter to the bell housing, and then pull the starter toward the front of the vehicle to remove.
To install:
Insert the starter into the bell housing being sure that the starter drive teeth are engaged with the flywheel teeth, NOT jammed against the flywheel.
Tighten the attaching hardware to 29 ft. lbs. (39 Nm) and replace all electrical connections.
Connect the positive battery cable (starter wire) to the starter.
Connect the negative battery cable.
Remove the nut and disconnect the battery cable from the magnetic switch on the starter motor.
Detach the remaining electrical connections at the starter.
Remove the nuts and/or bolts securing the starter to the bell housing, and then pull the starter toward the front of the vehicle to remove.
To install:
Insert the starter into the bell housing being sure that the starter drive teeth are engaged with the flywheel teeth, NOT jammed against the flywheel.
Tighten the attaching hardware to 29 ft. lbs. (39 Nm) and replace all electrical connections.
Connect the positive battery cable (starter wire) to the starter.
Connect the negative battery cable.
Image (Click to enlarge)
Feb 2, 2011 at 11:36 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.