AFTER NEW CLUTCH INSTALL IT WON'T TO INTO GEAR
1997 Mitsubishi Other • 125,000 miles
I have a 97 eagle talon tsi I just put a clutchmaster stage 2 6 puck clutch in it and when I start it won't go in gear its like its not engaging all the time. I just put a new clutch in my eagle talon tsi and when I start it won't go in gear and when I put it in gear and then start it it pulls itself with the clutch pushed all the way in and the clutch is really hard to push in
November 6, 2011.
November 6, 2011.
Recheck your installation it kinda sounds like your hydraulic clutch slave cylinder isn't working right and needs to either be bled or adjusted properly.
Without physically seeing it it's hard to diagnose what is exactly wrong with it. As long as the clutch install was done correctly it's either that or a bent release arm.
96 ford ranger 2.3l 2wd---hard to get into gear and grinds someitmes going into reverse. replaced- master cylinder, slave cylinder, throwout bearing, pressure plate, clutch disk, ...
3 answers • 1996 Ford Ranger • 192,000 miles
1998 Ford Mustang : I recently took my Mustang GT into a Ford service center for a slipping clutch. They told me that I have a self-adjusting clutch and that the clutch assembly needed ...
1 answer • 1998 Ford Mustang
1995 Nissan Maxima SE. Clutch began slipping about a week ago, then 'broke' loose and went to the floor as I was downshifting from 5th to 4th. Kabam! all the way to the floor and no ...
3 answers • 1995 Nissan Maxima • 270,000 miles
My car has been revving up even while in 5th gear and running on unusually high rpm's when any gas is applied, and it has had a burning brake smell if I drove it very far. Recently,the ...
2 answers • 2003 Mitsubishi Lancer • 130,000 miles