im having trouble getting to the bolt that holds oil collent line on to the block
whats the best way to remove it ..
whats the best way to remove it ..
Sep 29, 2011 at 3:36 AM
how to change oilcollent lines
1997 GMC JIMMY
MOSLEY70
- MEMBER
- 3 POSTS
- FOLLOW
Advertisement
if you have one of the universal type sockets then you can do it like that, you may haveto have alonger extension so you can get by the crossmember.
Sep 29, 2011 at 1:25 PM
thank you i will try it..
Sep 29, 2011 at 1:41 PM
It will be a lot easier with a 3/8" drive set and as mentioned extensions and universal joint, a standard 1/2" drive will just be to cumbersome for this job.
Sep 30, 2011 at 8:18 AM
thank you for info... i had to jack the moter up about an inch to have enough clearence to pull the lines out... its also easier to get your extensions and socket in which made it easier to install...
Sep 30, 2011 at 1:59 PM
thats good to hear, thank you for using 2carpros.
Sep 30, 2011 at 2:03 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.