SPONSORED LINKS

I just had the rack and penion, upper control.

Tiny
SANIYA2008
  • MEMBER
  • 1997 FORD THUNDERBIRD
  • 240,847 MILES
I just had the rack and penion, upper control arm and ball joints on both sides, repaired also the transmission gasket changed and not
I can only shift into reverse gear. It won't change into 1st, 2nd or drive gear.

Would any of these repairs, have anything to do with my gears not changing?

Your answer is deeply appreciated. Thanks.

Loretta Jones
SPONSORED LINKS
Sunday, November 4th, 2012 AT 6:30 PM

2 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check the fluid level, if it was just changed it may have eaten the clutch materials off due to new fluid with mileage you state. Have a trans guy look at it.
Was this
answer
helpful?
Yes
No
Sunday, November 4th, 2012 AT 7:30 PM
Tiny
SANIYA2008
  • MEMBER
  • 4 POSTS
Thanks, I will have a professionaly transmission gut look at it tomorrow.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, November 5th, 2012 AT 2:30 AM

Please login or register to post a reply.

Related Upper Control Arm Replace/Remove Content

Control Arm Replacement - Upper
GUIDE
Control Arm Replacement - Upper
Non strut cars and trucks are designed with an upper control arm that supports the top of the spindle which is where the wheel is mounted. Much like a lower control arm it...
VIEW MORE

Sponsored links