SPONSORED LINKS

1997 Ford Explorer Blinkers not working

Tiny
JADDAX
  • MEMBER
  • 1997 FORD EXPLORER
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 196,000 MILES
Blinkers were cutting off and on, now wont come on at all. I have replaced the Wiper/turn signal lever switch and the flasher relay. Checked the fuse it is still good. Any suggestions would be appreciated. Thanks
Tuesday, December 1st, 2015 AT 11:54 AM

3 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check your turn/hazard flasher that is in steering column. It's the switch assembly for hazard.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, December 1st, 2015 AT 12:14 PM
Tiny
JADDAX
  • MEMBER
  • 2 POSTS
Is that the same as the wiper/signal switch lever? It has two connection one for the hazards switch the other for signal light and wiper control. That part I just replaced. Hazzard light come on blinking, but turn signal wont. I replaced the turn signal switch last year, was still under warranty so I went ahead and replaced
Was this
answer
helpful?
Yes
No
Tuesday, December 1st, 2015 AT 1:06 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
No it is the hazard switch itself.
Was this
answer
helpful?
Yes
No
+1
Tuesday, December 1st, 2015 AT 1:39 PM

Please login or register to post a reply.

Related Turn Signal Not Working Content

Turn Signal Problems
GUIDE
Turn Signal Problems
Turn signals are intended to help inform surrounding drivers of the vehicle's intended change in direction. Although there are a few different causes for signal failure...
VIEW MORE

Sponsored links