is the clutch throw arm at the slave attached/moving like it should?

Answered by fixitmr
24 questions asked

I am not sure but i will check it, if not then what do i do ???

Response from LyndaB94
1 question asked

Also check the hose that runs from the master to the slave, it could be leaking under pressure. also just because your transmission repalcement parts are new does not mean they are GOOD, check them for loss of pressure.

Ben

Answered by transmissionman
0 questions asked

if the pedal stays down and the throw arm is moving then either you have a bad pressure plate or the arm is off the throw out bearing. is trans shifting? when it's at floor can you shift trans and not when it's up?

Answered by fixitmr
24 questions asked

thanks i will check them tomorrow and hopefully that will fix it if not i will let you know fixitmr .

Response from LyndaB94
1 question asked

of as far as shifting no it doesn't shift at all because because of the pedal having no pressure at all.

Response from LyndaB94
1 question asked

Is the pedal to master cylinder clearance adjusted correctly?
While bleeding, did the clutch fork move?

Answered by KHLow2008 (expert)
39,846 answers provided