transfer case back on I'm not able to put it into gear?

1996 FORD RANGER
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
I replaced the clutch, master cylinder, and slave cylinder and I'm able to shift but when i put the transfer case i cant get it into gear I'm able to shift when i don't put the transfer case but as soon as i put the transfer case back on I'm not able to put it into gear?
Oct 12, 2012 at 1:27 AM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
do you mean engaging the transfer case??

Roy
Oct 12, 2012 at 2:11 AM
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
no not by engaging i mean by putting back on the transmission
Oct 12, 2012 at 2:50 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
do you have the drive shafts installed??

Roy
Oct 12, 2012 at 2:55 AM
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
yes i do
Oct 12, 2012 at 3:07 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
does not make any sense. whether the case is in or not should not have anything to do with the engagement unless there is a failure in the transfer case.

why did you replace the clutch and what parts did you use??

Roy
Oct 12, 2012 at 3:09 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.