1995 Jeep Grand Cherokee Limited-overdrive doesn't work. the button doesn't work
Feb 19, 2011 at 11:45 PM
jeep grand cherokee 1995
1995 JEEP GRAND CHEROKEE
PHILANDPATTE
- MEMBER
- 2 POSTS
- FOLLOW
Advertisement
At the OD switch, use a jumper across the Orange and Black terminals and if the lights comes on, the switch is bad.
Check fuse # 21 (15A) in fuse block. It controls the switch illumination.
If light does not turn on and OD does not work, the transmission control module and its wiring has to be checked.
Check fuse # 21 (15A) in fuse block. It controls the switch illumination.
If light does not turn on and OD does not work, the transmission control module and its wiring has to be checked.
Feb 20, 2011 at 1:30 PM
The light is already on signifying that the OD is off. When I try to push it, it doesn't turn off and doesn't go into OD. Where is the transmission control module located, please. Thank you
Feb 20, 2011 at 3:50 PM
TCM is located behind left side of dash.
What is the transmission code for your vehicle? There are a few models and some are not equipped with TCM. Instead it is incorporated into the engine computer ( PCM)
What is the transmission code for your vehicle? There are a few models and some are not equipped with TCM. Instead it is incorporated into the engine computer ( PCM)
Image (Click to enlarge)
Feb 20, 2011 at 4:14 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.