windstar hesitation/stumble 800/1100 rpm

1995 FORD WINDSTAR
137,000 MILES
Avatar
TRASHMAN36
  • MEMBER
  • 2 POSTS
my 95 windstar has a dead spot/ hesitation from 800/1100 rpm. I have changed crank and cam position sensors. air idle motor throttle position sensor and electronic vac regulator.It runs fine after 1100 rpm and goes down the road smooth with plenty of power.I also just put new plugs and wires in. I have been told the maf could be the problem.any sugestions?
Jun 16, 2012 at 8:32 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Try cleaning it with an electronic cleaner and see what happens
Jun 16, 2012 at 8:36 PM
Avatar
TRASHMAN36
  • MEMBER
  • 2 POSTS
I have tried to clean it with maf cleaner.Is there any way to tell if they are bad?
Jun 16, 2012 at 8:51 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
You sure the transmission is not slipping? Go to this walk thru link:https://www.2carpros.com/articles/engine-has-low-power-output
Jun 16, 2012 at 10:32 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.