will turn over fine but won't start

1995 FORD PROBE
120,000 MILES • 6 CYL • FWD • MANUAL
Avatar
HOMER124
  • MEMBER
  • 5 POSTS
Hello everyone. I bought a 1995 probe gt for my first car a few months ago and it wasn't currently running due to the timing belt and the distributor. So i replaced them and ended up replacing the timing belt, distributor, water pump, oil pump, thermostat, air intake,spark plugs and a oxygen sensor and it won't start now. It did for a while but it quit all of a sudden. I am desperate. PLEASE HELP!!!! Its my first car and i just got my permit and i really want to drive it!!! Any responses appreciated. Thank you.
Dec 24, 2010 at 6:04 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Make sure you are getting spark and fuel to the engine. Make sure the timing is correct. If you have all three, it has to run unless you have low compression.
Mar 2, 2011 at 4:15 PM
Avatar
HOMER124
  • MEMBER
  • 5 POSTS
ok. thank you very much. it turns out i had a bad crankshaft positioning sensor and i wasn't getting spark all the time. thank you for your help.
Mar 2, 2011 at 10:33 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
That will do it. Let us know if you have questions in the future.
Mar 3, 2011 at 1:25 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.