1995 Chevrolet S 10 Hi Recently Replaced Stater Coil Ignition Module Etc

1995 CHEVROLET S-10
64,000 MILES
Avatar
JOJOS10
  • MEMBER
  • 10 POSTS
Hi, I recently replaced my stater, coil, and Ignition module "etc". On my truck I notice, when I insert the key in the ignition and don't press in but turn it over it start up very "strong" but if I press in to start it up, it start up sporadically not that strong start up when I don't press in... PS, when I press the key in the ignition to start it you don't get that strong start but more like a splash or a over starting noise, then when I take the key out and try to start it back up it will turn over but wont start, but if I wait to 3 min and don't press all the way in it start up very strong.
Dec 7, 2012 at 10:25 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Inspect and test the ignition switch-start here
Dec 7, 2012 at 10:58 PM
Avatar
JOJOS10
  • MEMBER
  • 10 POSTS
Okay, may I ask does this sound like a ignition switch problem I'm having?
Dec 7, 2012 at 11:00 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Sounds like it, but requires testing to rule it out and what caused it,as I suggested-again start here
Dec 7, 2012 at 11:12 PM
Avatar
JOJOS10
  • MEMBER
  • 10 POSTS
OK, thank you.
Dec 7, 2012 at 11:15 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.