COOLANT TEMPERATURE SENSOR LOCATION
1995 Chevrolet Blazer • 160,000 miles
95 Blazer has a 4.3l w/ multiport fuel injection. When I start it in the morning, it idles fine. When I drive it some and it starts to warm up, it skips when i accerlerate, like it is flooding. I let off and it idles fine, but as I accelerate, it acts like it is flooding again. When I shut it off and let it set a while, it then runs much better. I was told that the coolant temperature sensor. I purchased a new sensor that was listed for this vehicle. Trouble is, I can't find this sensor on the motor. On the drivers side of the head, there is a similar looking sensor. But this only has one wire on it. I took that off but found out that is the temperature switch. I got the correct replacement, but that doesn't make any difference in the prior problem. I still can't find the coolant temperature sensor, and don't know if it actually has one. The 96 sensor is located by the thermostat housing in th efront top of the motor. Any help is appreciated!!!
July 1, 2013.
July 1, 2013.
Just wondering what sensors i need to replace.codes as follows.p0135,p0155,p0133.two of the codes say bank 1 sensor 1 the other says bank2 sensor 1.I think bank means driver or ...
2 answers • 2002 Dodge Intrepid • 100,500 miles
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles