1994 Toyota 4Runner Repair Question
Topics covered: Clutch, Clutch master, Push rod.
Mileage: 125,000 miles.
Mileage: 125,000 miles.
Asked on October 17, 2011
Clutch sticks...but works!?
We put fluid in resevoir.Clutch does fine until u hold it down for anytime then it sticks?u have to reacxh down and pull it up. We took top off resevoir and pushed on clutch..NO MOVEMENT of fluid at all.Bled it .Any ideas?
Thx,
Glenda
Thx,
Glenda
Asked by Glenda L SmithAnswer
Replied on October 17, 2011
The clutch master cylinder is bad and leaking pressure internally. You need to have it repaired or replaced.
Replied on October 17, 2011
Thanks so much.We suspected same thing.But verification from u is what we needed.!!LET ME SAY THIS IS A FANTASTIC SITE..WITHOUT DOUBT!!!!!!!!!!!
Replied on October 18, 2011
You're welcome.
Have a great day.
Replied on October 19, 2011
HELP again!!! new clutch master cylinder but clutch STILL STICKS..aLSO CANNOT GET INTO GEAR.Now what?
Replied on October 26, 2011
Did you adjust the master cylinder to pedal push rod clearance correctly?
Too much clearance, meaning the clutch engages at a low pedal height, or insufficient clearance, a high pedal height can cuase the problem described.
Was the system bled correctly?
Is the slave cylinder leaking?