Will an OBD2 scanner work on a 1994 bonneville which is probably OBD1

1994 PONTIAC BONNEVILLE
220,000 MILES
Avatar
CHAPS
  • MEMBER
  • 1 POST
My bonne will not start. Check engine light on. connected OBD2 scanner but it did not read out codes. I have 42 lbs fuel pressure, but bonne acts as if it is not getting fuel. Checked fuel injector harness, have power but no pulse. Before I start disconnecting sensors, I thought it best to check the codes again.
May 5, 2012 at 7:29 PM
Advertisement
Avatar
MERLIN2021
  • CAR REPAIR CONTRIBUTOR
  • 17,250 POSTS
That obd II wont read obd codes. A paper clip can be used to jump the a and b terminals shich are.the two top right termknals. Insert the cclip and turn the keg on then count the flashes.
May 5, 2012 at 7:38 PM
Avatar
MERLIN2021
  • CAR REPAIR CONTRIBUTOR
  • 17,250 POSTS
There is a link on our home page for reading the counts to figure out the codes from the flasbing check engine light.
May 5, 2012 at 7:40 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.