Wont crank on way it cranks is if u spray.

Tiny
ANONYMOUS
  • MEMBER
  • 1994 FORD TRUCK
Wont crank on way it cranks is if u spray syarting fluid in it I changed the fuel filter and pump relay wont kick on changed it and still nothing
Monday, November 12th, 2012 AT 6:14 PM

2 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Did you check circuits at the fuel pump relay? The load side of relay has that line with arrowhead on it. You can see the fuse in the diagram. The coil side of relay has the squiggle line, the red wire is voltage for coil side of relay, comes from pcm power relay. The lite blue wire with orange tracer is ground for the coil side of relay, goes to ecm. You can also use jumper ground at proper pin at datalink connector, to ground relay, to see if pump will run. Any applicable trouble codes? In the diagram also note the inertia switch. I wasn't sure of engine litre size? I looked at f150 4.9L
Was this
answer
helpful?
Yes
No
Monday, November 12th, 2012 AT 6:38 PM
Tiny
ELLEN12
  • MEMBER
  • 7 POSTS
Please consult your mechanic, he will guide you better. Don't waste time.
Was this
answer
helpful?
Yes
No
Thursday, May 23rd, 2013 AT 2:22 AM

Please login or register to post a reply.

Sponsored links