I have a 93 Ford Ranger. There is a popping noise coming from front end when in 4 high and sometimes will not go in to 4 low.
Jan 21, 2011 at 2:09 AM
Advertisement
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
Check ball joints and the CV joints on the front end. Also, check u-joints. As far as the lo range, check to make sure the actuator is getting power on the transfer case. If it is, remove the actuator and check it for operation. It is common for them to go bad.
Mar 21, 2011 at 12:25 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.