2CarPros - Car Questions & Answers

1993 Chrysler New Yorker Repair Question


Topics covered: Fuel pressure, Gas, Gas pedal.
Mileage: 183,000 miles.

Asked on October 7, 2012

Cranks will not start

1993 Chrysler new yorker cranks will not start replaced cam shaft and crank shaft sensor have spark to plugs, when it did start and i stepped on gas pedal it hesitated and started to die, shut car off and tried to resart and it would not start, can here the fuel pump come on for 1 to 2 seconds the goes off, can a throttle postion sensor cause this
Avatar Asked by daddy43big

Answer

Replied on October 7, 2012

no, start with basics.

compression, for timing belt, fuel pressure, even though you hear the pump running, and spark test

Roy

Tiny Answered by ASEMaster6371 (expert)
24,973 answers provided
Replied on October 7, 2012

those are all good

Tiny Response from daddy43big
5 questions asked
Replied on October 7, 2012

When it does start and it is put in gear it starts to die also, when i stepp on gas pedal it does not act as if it is going to die

Tiny Response from daddy43big
5 questions asked

Replied on October 7, 2012

then it does drive??

is there any codes??

what is the actual fuel pressure??

Roy

Tiny Answered by ASEMaster6371 (expert)
24,973 answers provided
Replied on October 7, 2012

it drives when i can get it started, no codes, 14 lbs pressure

Tiny Response from daddy43big
5 questions asked
Replied on October 7, 2012

needs 45-48 lbs of fuel pressure to make things work right

Roy

Tiny Answered by ASEMaster6371 (expert)
24,973 answers provided