1993 Chevrolet Truck Repair Question
Topics covered: Clutch, Clutch master, Clutch pedal.
Mileage: 171,000 miles.
Mileage: 171,000 miles.
Asked on October 24, 2012
Chevrolet Truck Clutch Problem
Do you have to take the trans. out to replace the slave cylinder on a 5 speed standard
Asked by (pending member)Answer
Replied on October 24, 2012
When servicing the clutch actuator with hydraulic line intact, disconnect the clutch master cylinder pushrod from the clutch pedal in order to prevent damage to the actuator should the pedal be depressed.
Raise and support vehicle, then remove actuator cylinder to clutch housing nuts and actuator assembly.
Use hydraulic clutch line separator tool No. J-36221 or equivalent to disconnect actuator cylinder hydraulic line coupling, then remove line from clips if necessary.
Reverse procedure to install, noting the following.
