Removal (Bronco& F-Series Pickup)

Disconnect the battery ground cable.
Remove the door trim panel and watershield. See DOOR TRIM PANEL .
Disconnect power window motor wire from wire harness connector. See Fig. 13 .
Check inside the door to make sure electrical wires are not in line with holes to be drilled in the door inner panel. Using a 1/2-inch (12.7mm) diameter drill bit, drill two holes in the door inner panel at the drill dimples located opposite the two unexposed motor drive retainer screws.
Remove the three motor mount retainer screws using two drilled holes and existing larger hole access to screw heads.
Push the motor toward the outside sheet metal to disengage the motor and drive from the regulator gear. After the motor and drive are disengaged, prop the window in full UP position.
Remove the motor and drive from inside the door. See Fig. 13 .

Answered by rasmataz
68 questions asked