Whats the fastest and easiest way to replace a heater blower motor mine went out and its the middle of winter!
Jan 13, 2011 at 2:27 AM
Heater blower motor
1992 CHEVROLET TRUCK
JORDAN1991
- MEMBER
- 1 POST
- FOLLOW
Advertisement
There's no short cut her-see below
REMOVE OR DISCONNECT
Front screw from right door sill trim plate.
Right hinge pillar trim panel.
Electrical connectors, as necessary.
Blower motor cover.
Vent hose.
Courtesy light (if equipped).
Loosen courtesy light screws and move light aside (if equipped).
Bolt from right dash support.
Blower motor flange screws.
Blower motor.
May be necessary to pry back dash.
Blower motor fan.
REMOVE OR DISCONNECT
Front screw from right door sill trim plate.
Right hinge pillar trim panel.
Electrical connectors, as necessary.
Blower motor cover.
Vent hose.
Courtesy light (if equipped).
Loosen courtesy light screws and move light aside (if equipped).
Bolt from right dash support.
Blower motor flange screws.
Blower motor.
May be necessary to pry back dash.
Blower motor fan.
Image (Click to enlarge)
Jan 13, 2011 at 2:47 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.