no start. has good compression and fuel pressure is good. need pin point diag
Sep 4, 2012 at 12:03 PM
Not getting engine to start
1991 VOLVO 940
ASEMASTER6371
- ✓CAR REPAIR CONTRIBUTOR
- 52,796 POSTS
- FOLLOW
Advertisement
Most likely the crank sensor is the one causing the problem, commonly known to fail suddenly.
Turbo or non turbo?
Pin point diagram of what?
Turbo or non turbo?
Pin point diagram of what?
Sep 4, 2012 at 12:11 PM
Turbo.
Thanks will check it out.
Roy
Thanks will check it out.
Roy
Sep 4, 2012 at 12:13 PM
You're welcome.
The sensor wire coverings becomes brittle over time and heat and once you touch it, most probably you would need to replace it.
Have a nice day.
The sensor wire coverings becomes brittle over time and heat and once you touch it, most probably you would need to replace it.
Have a nice day.
Sep 4, 2012 at 12:59 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.