i did an engine swap from a 305 to a 350 is it best to switch th ecm?

1991 CHEVROLET CAMARO
Avatar
RA.CHIVAS.RA
  • MEMBER
  • 14 POSTS
i have a code 43 on my car i read that it comes from the knock sensor being bad or the esc i put a new knock sensor and connector the esc is in the ecm correct? and if so would it be easier to jus switch out the ecm with one of the same year for a 350?

Oct 3, 2012 at 5:46 AM
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
If you have a wiring fault, replacing the ECM is not going to work. ECM need not rbe replaced, it is the MEM-CAL that has to be replaced if it is faulty. Check this out to see if it is of any help.
Images (Click to enlarge)
Attached Media
Attached Media
Oct 3, 2012 at 6:54 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.