G problems installing new chain

Tiny
KEDGENZ
  • MEMBER
  • 1986 NISSAN VAN
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 280,000 MILES
Hi guys,

I am a little confused here so maybe somebody can help me out.

I got a copy of the Nissan service manual for my z24 1986 Nissan Nomad or Vanette.

Replacing head gasket and a new timing chain and tension-er and gears but having problem with installation.

My new timing chain has no marks or gold links on it to align the gears with the chain. So how do I do it but my chain has a link in it can I use this?


The other thing is there has been a new head put on not to long ago before I got the van. It is shiny compared to the block.

The front of the engine I am assuming is cylinder one.

I have set TDC on the crankshaft with a screw driver and key-way on the crank is sitting at the top. My head is set so that it has just finished the exhaust and ready to push on the inlet thinking this is my TDC on the head. Problem is that my manual says that the alignment pin on the cam shaft should be at the top and in the case it is at the bottom if I turn the cam so it is at the top then it is on its compression stroke.

Any help out there?

Thanks.
Kevin
Sunday, May 8th, 2011 AT 5:10 AM

4 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
The color of the link does not matter just make sure it is on number one piston at compression/TDC and align the markings on the cam and crank sprocket as indicated below.
Was this
answer
helpful?
Yes
No
+11
Sunday, May 8th, 2011 AT 8:27 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
The links are not colored and only plated which makes it difficult to spot. S light held over the chain should help. The most important thing to ensure is that the cam and crank sprockets have forty four links in between them.
Was this
answer
helpful?
Yes
No
+1
Sunday, May 8th, 2011 AT 12:03 PM
Tiny
KEDGENZ
  • MEMBER
  • 4 POSTS
What I did in the end was counted the links on the old chain and then remarked it on the new chain then realigned the marks on the diagram and the new marks I made on the chain and it all lined up.

Thanks for you help.
Kevin
Was this
answer
helpful?
Yes
No
Sunday, May 8th, 2011 AT 8:48 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
You are welcome.

Have a nice day.
Was this
answer
helpful?
Yes
No
Monday, May 9th, 2011 AT 1:39 PM

Please login or register to post a reply.

Sponsored links